ASKER - TYPE JAL

Durometer EX Version

Brand : ASKER (Made in Japan)

Type  : JAL


The ASKER Durometer Type JA for generalrubber, conforming to the specifications of

 It complied with Spring type hardness tester Type A   in the formerly applicable standards of JIS

J6301"Physical Testing Methods for Vulcanized  Rubber", abolished in Aug, 1998. However, it is    used even now for measurement data or internal   management data upon the agreement of  concerned parties due to its extensive use    historically within the rubber industry.


 
Description
Features
Indentor
Height: 2.54mm Shape: Flat Cone Point
Hardness Tester Selection Chart
Our product line consists of various types of durometers applicable to specific materials
as indicated in the chart above.

Type A Durometer (ASKER A type), conforming to JIS K 6235 is the most popular type of durometer for measuring rubber hardness.

However, verification is recommended because a significant difference is estimated to be the largest when a durometer indicates measurement values from 10 to 90 points.

For hard specimens for which Type A Durometer readings indicate more than 90 points, measurements should be undertaken using the Type D Durometer (ASKER D type). However, for soft specimens with measurements of less than 20 points, the ASKER C type or Type E Durometer (ASKER E type) should be used. The most important consideration in using durometers is to select the correct type for purposes of measurement according to the specimen.


Option
 
Standards JIS K 6301
Indication range 0 point - 100 point (262 degree dial scale)
Minimum indication 1 point (Accuracy : ±1 point)
Indentor Design (mm) Height: 2.54mm 35°Angle Flat Cone Point 0.79 Dia.
Spring Forces [mN(g)]
0 point: 539(55)
100 point: 8379(855)
Central hole of diameter of Pressure foot Φ3
Pressure foot
Dimension (mm)
Φ12 Longer foot type Length: 18
Outer Dimension (mm) Approx. Width 57×Depth 30×Height 94
Weight (g) 200
Application general rubber, soft plastic


Outer Dimension (mm)
A custom designed pressure foot durometer is available according to specimen conditions.

Option
  Two-pointer type (max-hand and active hand) of Rubber Hardness Tester
The stationary set hand (max-hand) makes the maximum value easier to read and allows the creep characteristics of a specimen.

Accurate measurement is made possible for specimens* for which stress relaxation occurs over time or for specimens for which it is difficult to take readings from the front.

*Materials for which the reading decreases immediately after the indentor has been pressed against the surface.
  Constant Loader for Durometer
· Constant loarder assures uniform test pressure eliminating false readings due to differences between operators in measuring by hand.
· High accuracy and repeatability of the hardness readings are assured by the flexible joint function.
  Indentor Extension Tester
· The gauge to check the indentor height on a durometer and the reading indicator mechanism.
· Inspection is conducted at 2, 50, and 100 points respectively.
  Load Tester for Hardness Tester
· Tester to check load properties of the spring on a durometer
· Inspection is conducted at 2, 50, and 75 points respectively.
Visitors: 46,231